There may be some of the less know how panning eluvial gold ore found on the path of the river or the prospect area which contains metallic gold ore, and how to identify alluvial gold in river to obtain a suitable sample of gold ore. The place to look for gold eluvial including creeks and ditches along the sides of hills and in depressions between the hills. Alluvial deposits occur on the hillsides and in the hollows between the hills. Then we tried along the river, which at the start of a bend in the curve of the river downstream side or bend in the river because it is usually gold ore are often stuck in there. And we can try to take a few handfuls of sand sediment and then washed with a platter.
By using equipment made from plastic pots or metal we can do an analysis of eluvial gold ore. And we also need to separate magnetic metal with a gold metal content of iron ore. Before you use these pans equipment wash with soap to remove any residual oil from the sometimes still tied at the bottom of the pan.
Step in gold panning:
Look for areas in the bend of the river that have a prospect of the gold mineral ore. Then fill the pot you use for gold panning with sand, soil and gravel that you think have gold content of ore minerals.
To begin the next step place the pan on the bottom of the water and gently shake pan and rotate them. Then tilt the pan for some materials rough stone are in a position above the rough and then you throw rocks slowly by hand. Indirectly mineral ore will be under because of the force of gravity, and gravity of gold metallic minerals and rocks
Now turn and shake the pan back gold from side to side and pull it backwards, while partially submerging under the water pan. While such set up a tidal wave This allows each particle of gold is not out of the pot but was trapped at the bottom of the pan.
Tilt the pot of gold with the tip away from you slightly under water. While your hands are still shaking while positions remain as they are side to side, sink, lift and out of the water and tilted back, allowing it to form a wave. Tip forward again, letting the waves travel ahead to take out of the pan. Next turn back the pan from side to side again so that the metal back on the bottom of the pan
Some of the previous steps should be repeated until the only remaining approximately one tablespoon of the remaining fine material. This action is necessary to gently wash the used amount of dirt remaining. Eventually will be seen a few grains of fine gold ore at the bottom of the pan but still there are some impurities. To eliminate some black dirt that is most likely iron ore sand, we can use a magnetic metal to take it. Place a magnetic metal in a plastic bag so that the black sand collected on the outside of the magnetic metal for iron ore can be easily retrieved from a magnetic metal.
To eliminate some black dirt that is most likely iron ore sand, we can use a magnetic metal to take it. Place a magnetic metal in a plastic bag for iron ore can be easily retrieved from a magnetic metal. then enter a magnetic metal into a pot which contained gold ore, then iron ore will stick to the magnetic metal, while gold ore will be fixed and does not stick
Gold spots can then be collected with wet fingers and placed in sample bottles filled with water. A teaspoon is useful to collect the gold when present in large numbers
Here are some gold panning equipment with low price that you can use : Gold Panning Equipment
Read Also :
/*